Questions And Answers

# List All Questions Search List by Category
Question Do solder irons have to measure resistance between the tip of the hotsoldering iron and the workstation ground less than 5 ohms and 2 mV RMS? - Anonymous
Answer The ESD DS13.1, which I believe is was published after the ANSI/ESD S20.20, states in section that the soldering Iron Tip-to-Ground Resistance Measurement shall be equal to or less than 2.0 ohms (20 mV – reading from millivolt meter used in conjunction with a current meter so 0.1 ohm = 1.0 mV).
Related Categories:
If you have found this Q/A useful, please rate it based on its helpfulness.
Rating Rating Rating Rating Rating
This question has been rated: 0%0%
(0% at 0 Ratings)